Dhcp Server Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – DHCP
H3C S9500 Series Routing Switches
Debugging the DHCP server:
Disable debugging for the
DHCP server
Enable debugging for the
DHCP server
Clearing the specified information of the DHCP server:
Clear the statistics about
DHCP address conflicts
Clear the information
about dynamically bound
addresses
Clear the statistics about
the DHCP server

2.3 DHCP Server Configuration Example

I. Network requirements
As shown in
are connected to the switch through a port in VLAN2. The switch, acting as a DHCP
server, is supposed to assign IP addresses to the two DHCP clients without the help of
any DHCP relay agent.
II. Network diagram
DHCP client
Switch ( DHCP Server)
Figure 2-1 Network diagram for DHCP server
III. Configuration procedure
# Enter system view.
<H3C> system-view
To do...
undo debugging dhcp server { all |
error | event | packet }
debugging dhcp server { all | error |
event | packet }
To do...
reset dhcp server conflict { ip
ip-address | all }
reset dhcp server ip-in-use{ all |
interface [ vlan-interface vlan-id ] |
ip ip-address | pool [ pool-name ] }
reset dhcp server statistics
Figure 2-1, two DHCP clients on the same network segment (10.110.0.0)
DHCP client
10.110.0.0
Ethernet
10.110.1.1
Chapter 2 DHCP Server Configuration
Use the command...
Use the command...
2-15
Remarks
Available in
user view
Remarks
Available in user
view