H3C S9500 Series Operation Manual page 22

Operation Manual – ARP
H3C S9500 Series Routing Switches
II. Network diagram
PC
Figure 2-1 Diagram for ARP table size configuration
III. Configuration procedure
# Configure the maximum number of ARP entries supported by the whole switch as
64K.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] arp enable size 64
The configuration won't be enabled until the system is rebooted
# Configure the maximum number of ARP entries supported by the interface card in slot
2 as 8K.
[H3C] arp max-entry 2 8
The configuration won't be enabled until the system is rebooted
# Configure the maximum number of aggregation ARP entries supported by each
interface card in the system as 8K.
[H3C] arp max-aggregation-entry 8
The configuration won't be enabled until the system is rebooted
Restart the system for the configurations to take effect.
Chapter 2 ARP Table Size Configuration
Switch
2-4