important notes Please take a few minutes to read this user guide. Lay the parts out on the floor and compare to the parts checklist (below). Do not discard any packaging until you are sure that you have all the parts. parts check list Plinth Upper...
Page 3
fig 3 Insert dowels into the large holes in the sides, in the positions shown, (3 dowels in each). fig 4 Screw a cam pin into the small hole, as shown, on each side. Insert cams into the largest holes, near the top of both side panels.
Page 4
fig 7 Insert the back panel (best face towards the rear) into the grooves in the rear rails and slide it down into the groove in the side. Attach the other side, taking care that all the cam pins and dowels enter the correct holes and that the back panel enters the groove at the rear.
Page 5
fig 10 Make sure the chest is on a level surface. Attach the back brackets to the outside back, pushing the narrow end between the groove and the back panel. Tighten the screws to make the structure rigid. fig 11 Screw cam pins, (2 in each drawer front), into the smaller holes;...
Page 6
fig 14 Attach the drawer backs using 6 screws (35mm) for each. Do not over tighten. fig 15 Engage the drawers on the runners. Attach the knobs using 35mm screws. With the drawers a little more than half way open, notice the holes in the sides, towards the back.
Need help?
Do you have a question about the chest of drawers and is the answer not in the manual?
Questions and answers