Enabling Wps Push Button Pairing - SAGEMCOM F@st 5260 User Manual

Sagemcom F@st 5260

Enabling WPS Push Button Pairing

Wi-Fi Protected Setup (WPS) push button pairing provides an easy way to join devices to
your Wi-Fi network with the push of a button. By default, WPS is disabled. To enable it,
follow the instructions below:
1. Log in to the web GUI.
2. Click on the network you want to configure.
Note: You should enable WPS on both Wi-Fi networks to easily pair devices to either
network using the WPS button.
3. In the WPS tab, slide the Enable WPS switch to ON.
4. Under WPS Mode, leave the selection to the Push Button default and PIN.
5. Click Apply.
6. To add a device to your network, press the WPS button located on the side panel of your
router to enable easy pairing.
• Press and hold the WPS button for 5 seconds until the WPS light flashes to enable WPS
push-button pairing mode.
• If your device supports WPS pairing, it should connect as soon as you select the Wi-Fi
network.
Chapter 2:
Getting Started
20