RCA DVR2080 User Manual page 80

References
78
8. Press the catch tabs near the screw you just loosened (one tab is above the
screw and one is below), and remove the entire lamp access door. Place
the door to the side (don't put it on the floor or anywhere someone might
step on it or accidentally break the tabs).
9. Loosen the screw on the lamp unit inside the TV (the screw stays with
the unit so just loosen it, don't remove it).
Service Model
Number
Sticker with
Lamp Part
Number
10. As you remove the lamp, pay attention to how the lamp fits so that you
can use the proper orientation when you're installing the new lamp. To
remove the lamp unit:
• grasp the handle and pull straight back to remove the entire lamp
assembly unit from the TV.
• place the old unit out of the way where it won't get broken or
dropped.
11. Remove the new lamp assembly unit from its packaging. Make sure you do
not touch the glass surface of the lamp.
12. Make sure the lamp unit is oriented in the correct position, and gently slide
it into the lamp access opening as far as it can go (it fits snugly).
13. Tighten the screw on the new lamp unit.
14. Put the old lamp unit into the box in which the new lamp unit was
packaged.
Chapter 5