Measure Mode Menu - Extech Instruments CG304 User Manual

MEASURE MODE MENU

1. Press the LEFT button to access the programming menu
2. Use the UP/DOWN buttons to scroll to the Measure Mode
3. Press the LEFT button (SELECT) to select the Measure Mode
4. Use the UP/DOWN buttons to scroll to Auto, FE, or NFE. Press the LEFT button (SELECT) to
make a selection.
In the AUTO mode, the meter automatically recognizes the metal that is being measured.
In the Ferrous (FE) Mode the Magnetic induction measurement mode is used.
In the Non-Ferrous (NFE) Mode the eddy current measurement mode is used.
5. Press the RIGHT button (BACK) to return to the normal operating mode.
SET MENU
Press the LEFT arrow to enter the menu.
1.
Use the UP/DOWN arrows to scroll to SET.
2.
Press the LEFT button (SELECT) to open the SET menu.
3.
a. Units of measure selections
From the SET menu, scroll to the UNITS selection if necessary. Press the LEFT button
(SELECT) to open UNITS. Select µm or mil using the arrow buttons (µm = micrometers;
mils = mm*2.54/100). Press the LEFT button (SELECT) button to confirm and to return to
the SET menu (otherwise press the right button [BACK] to abort the edit and return to
the SET menu).
b. Backlight
From the SET menu, scroll to the BACKLIGHT selection. Press the LEFT button (SELECT) to
open BACKLIGHT. Use the UP and DOWN arrows to adjust the brightness of the backlight.
Press the RIGHT button (Back) to confirm and return to the SET menu.
c. Auto Power OFF
From the SET menu, scroll to the Auto Power OFF selection. Press the LEFT button
(SELECT) to open Auto Power OFF. Select ENABLE or DISABLE using the arrow buttons.
When enabled, the meter automatically switches OFF after 3 minutes of inactivity. When
disabled, the meter will only switch OFF with a power button press or when the battery
power is weak. Press the LEFT button (SELECT) button to confirm and to return to the SET
menu (otherwise press the right button [BACK] to abort the edit and return to the SET
menu).
d. Bluetooth
From the SET menu, scroll to the BLUETOOTH selection. Press the LEFT button (SELECT)
to open BLUETOOTH. Select DISABLE or ENABLE using the arrow buttons. If Disable is
selected the Bluetooth will be switched OFF. When Bluetooth is enabled, data will be
automatically sent to PC, phone, or other Bluetooth receiving device.
When the first connection is being made the device may prompt for a PIN number. In this
case enter code 0000.
6 CG304-en-GB_v2.3 5/17