Napoleon Auburn NPS40 Installation And Operating Instruction page 23

CLEANING THE HEAT EXCHANGE TUBES
WARNING:
The front edge of the hopper lid becomes very
hot, do not touch the area below the handle.
Figure 27
WARNING:
This rod becomes very hot during operation. Use
the scraper tool to move the cleaner rod.
The scraper tool is stored on the magnetic catch
inside the left side door.
With the heater cool (or using the scraper tool), slide
the heat exchange cleaner rod up and down several
times.
Keep the viewing door closed so the fl y ash does not
enter the room.
Note: More frequent cleaning may be required de-
pending upon pellet quality.
VACUUM HOPPER
Run the heater until the pellets run out, then open
the hopper and vacuum out the entire hopper. The
dust and any other debris near the bottom should be
removed to prevent excessive build-up.
Cleaning the Optional Plated Surfaces
Fingerprints or other marks left on plated surfaces
may become etched in place if they are not wiped
clean prior to turning the heater on. Wipe the gold
with a non-abrasive cleaning solvent and a soft cloth
(make sure the heater is cool). Other cleaners may
leave a fi lm that may become etched into the fi nish.
BI-WEEKLY (
OR EVERY 10 BAGS OF PELLETS
BRUSH ASH INTO ASH PAN
The more often you clean out the fl y ash, the more
effi cient your heater will burn.
WARNING:
The fi re box becomes very hot during operation.
Let the heater cool completely before conducting
service.
1. Open the viewing door. See Figure 20 and 21
2. Lift the burn pot out of the fi rebox by using the
cleaning tool. Make sure the burn pot has cooled
before removing. Set burn pot on a
non-combustible surface.
3. Brush all fl y ash through the hole into the ash pan.
4. Replace the burn pot, close the viewing door and
close both side doors.
)
Figure 28
Figure 29
W415-0587
23