Advertisement
Place the PXI/PXI Express module edges into the module guides at the top and bottom of
the chassis, and slide the module into the chassis until the module is fully inserted, as shown
in Figure 5.
1
PXI/PXI Express Chassis
2
PXI/PXI Express System Controller
3
NI FlexRIO FPGA Module (PXI shown)
Figure 5. Installing an NI FlexRIO FPGA Module in the PXI/PXI Express Chassis
5.
Secure the device front panel to the chassis front panel mounting rail using the front panel
mounting screws.
6.
Plug in and power on the PXI/PXI Express chassis.
Confirming That the Device Is Recognized in Measurement &
Automation Explorer (MAX)
To confirm that your device is recognized, complete the following additional steps:
1.
Select Start»All Programs»National Instruments»Measurement & Automation.
2.
Expand Devices and Interfaces.
3.
Verify that the device appears under Devices and Interfaces»RIO Devices, as shown in
Figure 6.
© National Instruments Corporation
2
3
Figure 6. Confirming That the Device is Recognized
1
P X
I - 1
0 0 0
B
6
5
4
4
Front-Panel Mounting Screws
5
Module Guides
6
Power Switch
7
NI FlexRIO FPGA Module Installation Guide
Advertisement
