Advertisement
Installing the NI FlexRIO FPGA Module
Complete the following steps to install an NI FlexRIO FPGA module:
Note
You must install the software before installing the hardware. For software
installation information, refer to
Caution
document packaged with your PXI/PXI Express chassis or device before removing
equipment covers or connecting or disconnecting any signal wires.
1.
Power off and unplug the PXI/PXI Express chassis. Refer to your chassis manual to install
or configure the chassis.
2.
Identify a supported PXI/PXI Express slot in the chassis. Figure 4 shows the symbols that
indicate the slot types in a PXI/PXI Express chassis.
1
PXI Express System Controller Slot
2
PXI Peripheral Slot
3
PXI Express Hybrid Peripheral Slot
Figure 4. Symbols for PXI Express/PXI Express Hybrid/PXI Slots
If you are using a PXI Express chassis, you can place PXI devices in the PXI slots. If a PXI
device is hybrid slot compatible, you can use the PXI Express Hybrid slots. PXI Express
devices can be placed only in PXI Express slots and PXI Express Hybrid slots. Refer to the
chassis documentation for details.
3.
Remove the filler panel of an unused PXI/PXI Express slot.
4.
Touch any metal part of the chassis to discharge any static electricity.
NI FlexRIO FPGA Module Installation Guide
Refer to the Read Me First: Safety and Electromagnetic Compatibility
NI PXIe-1062Q
Step 1. Install the Application Software and
1
2
4
PXI Express System Timing Slot
5
PXI Express Peripheral Slot
6
3
4
Driver.
5
ni.com
Advertisement
