Silk'n Motion H3220 Instructions For Use Manual page 17

You are now ready to use your Silk'n Motion
1. Before treating an area, the skin should be shaved, clean, dry and free
of any powders, antiperspirants or deodorants. Do not wax, pluck
or tweeze the hair out.
M
Be sure to cover up moles, warts or other marks on the skin
that should not be treated.
2. Press the control button. The device will turn on, the level 1 energy
indicator light will be on, and a fan sound will start.
3. Approximately 1 second after pressing the control button, the ready
light will turn on. The device is then ready to use at the lowest energy
level.
Set the energy level. Press the control button repeatedly to increase
4.
the energy level until you have the level you want. The energy level
indicator lights indicate the energy level setting (refer to section "8.2
Energy levels").
Decide if you wish to treat the area by Gliding or Pulsing (refer to
5.
section "8.3 Pulsing and gliding").
6. Apply the treatment surface to the skin. Make sure that the skin is
spread evenly and smoothly. When the treatment surface is in full
contact with the skin, the ready light will start blinking slowly.
7. The device will first determine the colour of your skin automatically
and it will flash a pulse of light onto your skin. You will feel a mild
sensation of warmth and tingling, and you may hear a popping
sound.
8. If you are pulsing, remove the device from your skin. The device
will immediately recharge for the next pulse. After a few seconds
(depending on the energy level) the ready light will turn on again, and
start blinking slowly when pressed against the skin. If you are pulsing,
repeat the process. If you are gliding, simply continue.
9. Continue to pulse or glide until you have treated the area fully.
E
Stop use immediately, if your skin blisters or burns.
15
EN