Safety; Cleaning - IMC SP12 Installation And Operating Manual

SP-Range

SAFETY

All SP-Range peelers are controlled so that if the electricity supply is interrupted
the machine will not restart automatically.
All single phase SP-Range controls are fitted with a thermal trip. This ensures that
the controls cannot overheat and become damaged. If the thermal trip cuts in, the
machine will not run until it has cooled down and the peeler is switched off and on
again. The controls will not overheat in normal usage.
Do not put hands into the machine while it is running.
On single phase machines do not unplug the unit with wet hands.

CLEANING

It is essential to clean the machine at least once a day, preferably at the end of
each period of operation.
1 Switch off at the socket or isolator.
2 Remove the lid and splash cover.
3 Lift out the peeling plate.
4 Clean the peeling plate and cylinder in a sink, potwash or by hosing with a
spray.
5 Rinse the inside of the peeling chamber and base with warm water, using a
mild detergent if necessary to remove starch build up.
6 Wipe the exterior of the machine with a damp cloth, again using a mild
detergent if required.
DO NOT USE CLEANING MATERIALS CONTAINING ABRASIVES OR
BLEACHES.
DO NOT STEAM CLEAN.
DO NOT CLEAN WITH A WATER JET.
8