Table of Contents
Advertisement
STEP 3: CONNECTTH
E G-LINK
CABLE
The G-LINK cable enables the Guide Plus+ system (the on-screen guide
that lists what shows are on TV) to work with your VCR and/or cable box.
Cable Box - If your TV is connected
to a cable box and you don't
connect the G-LINK cable, no channels may be listed in the on-screen
program guide.
VCR - If your TV is connected to a VCR and you don't connect the G-LINK
cable, one-touch
recording
won't
work. The other features
of the guide
will work properly.
HOWTO
FINDTHE
REMOTE
CONTROL
SENSOR
You have to place the wands on the G-LINK cable in front of the remote
control
sensor on the VCR and/or cable box. Some cable boxes and VCRs
have the remote control
sensor labeled on the unit. If the remote sensor
isn't labeled on your VCR and/or cable box, you need to use the remote
control
that came with the VCR and/or cable box to locate the sensor.
1.
Turn off the VCR and/or cable box.
2.
Hold the remote control
(not the one that came with your TV, but
the one that came with the cable box and/or VCR) so it is touching
the front of the component.
3,
4,
5.
Slowly move the remote control
across the front
of the component
(VCR or cable box) while you press the power button
on and off.
You must press and release the power button
each time you move
the remote (holding
down the button
won't
work).
When the component
turns on, you've located the sensor.
Place the wands of the G-LINK cable underneath
your VCR and/or
cable box (see instructions
below).
The G-LINK cable is used to send commands
to your VCR and/or cable box. You must
remove the DEMO PiN before you can attach
the G-LINK cable.
PLACI NG TH E WAN
DS UN DE R TH E VCR AN D/
OR CABLE BOX
Place the wands of the G-LINK cable underneath
your VCR and/or cable
box. Place them about
one inch away from
the remote
control
sensor.
[]l
G-LI_K wand with a twist ti
and
leave
it behind
the TV.
tie and
leave
it behind
the
TV.
Connect to G_LINK i_k
on the
back
of the
T_
9
Hide quick links:
Advertisement
Table of Contents
