Why You Should Connect This G-Link Cable; How To Find The Remote Sensor; Placing The G-Link Wands - RCA F19436 User Manual

Thomson/rca television user's guide
Hide thumbs Also See for F19436:
Table of Contents

Advertisement

Connections & Setup
G-LINK cable
G-LINK wands
Tip
If you don't have both a cable
box and a VCR connected to
your TV, just coil the cable of
the extra G-LINK wand with a
twist tie and leave it behind
the TV.
12
1571963A.01 Setup

Why You Should Connect This G-LINK Cable

The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program
guide) to work with your VCR and/or cable box.
Cable Box – If your TV is connected to a cable box you must connect the G-LINK cable
to receive TV program listings for your area, and to tune directly to a channel when the
program guide is on your TV screen.
VCR – If your TV is connected to a VCR and you don't connect the G-LINK cable,
one-touch VCR recording won't work. The other features of the guide will work
properly.

How to Find the Remote Sensor

You have to place the G-LINK wands in front of the remote sensor on the VCR and/or
cable box. Some cable boxes and VCRs have the remote sensor labeled on the unit. If
the remote sensor isn't labeled on your VCR and/or cable box, you need to use the
remote control that came with the VCR and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but the one that came
with the cable box and/or VCR to which you're attaching the G-LINK cable) so that it
is touching the front of the component.
3. Slowly move the remote control across the front of the component (VCR or cable
box) while you press the power button on and off. You must press and release the
power button each time you move the remote (holding down the button won't
work).
VCR
4. When the component turns on, you've located the remote sensor.

Placing the G-LINK Wands

Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box
approximately one inch away from the remote sensor (see instructions below).
TV (back panel)
INPUTS
R
L/MONO
AUDIO
VIDEO
Connect to G-LINK jack
on the back of the TV.
SENSOR
12
CABLE BOX
ANTENNA
G-LINK
VCR
4/9/02, 12:58 PM
CHANNEL
03
CHANNEL
SENSOR
03
Chapter 1

Advertisement

Table of Contents
loading

Table of Contents