Download Print this page

Advertisement

Quick Links

Digital Measurement Metrology, Inc
SR100 Surface Roughness Tester
Operating Guide
ArDA Windows
Traverse Unit
Digital Measurement Metrology, Inc
PRECISION IS OUR VISION
Stylus
Start Buttons
ON Button
TM
Mode status
Display
Parameter Status
Parameter Selector
Mode Selector
Control Unit
1-866-960-9400
www.dmm.ca

Advertisement

loading
Need help?

Need help?

Do you have a question about the SR100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Starrett SR100

  • Page 1 Digital Measurement Metrology, Inc SR100 Surface Roughness Tester Operating Guide Mode status Display Parameter Status Parameter Selector Mode Selector Start Buttons ArDA Windows Control Unit Traverse Unit ON Button Stylus Digital Measurement Metrology, Inc 1-866-960-9400 www.dmm.ca PRECISION IS OUR VISION...
  • Page 2 Unit on the surface Then replace the battery covers. After as shown the batteries have been changed, there will be a short delay when the SR100 is turned on. The SR100 can be operated in two modes: Remote or Connected.
  • Page 3 5.81µm and the Rz value 21.5µm. Set Up Procedure If there is an error, an E code is displayed (see A new SR100 is fully set up out of the E Codes). box. However, if the pick-up is changed or...
  • Page 4 Control Unit: (1) 3V Lithium 2450 Traverse Unit: (3) 3V Lithium 2450 E13: <Reserved> Units: µin or µm E14: Traverse Unit - Electronic Measurement er- ror. Retry. If fault is persistent, contact Starrett Operating conditions: 50-95 F (10-35 C) 80% RH non-condensing Size: 4.92 x 3.15 x 1.5"...