Introduction; Preparation; Resources Required - Lippert Components Solera Installation And Owner's Manual

Introduction

The Solera Family Room and Screen Room are designed
®
for use on Solera Classic, Solera Hybrid and Solera
12V power awnings, Carefree Fiesta, Spirit, Pioneer
manual, Traveler & Eclipse 12V power awnings, Dometic
Sunchaser, 8500 manual, Weather Pro and 9100 series
12V power awnings.
Additional information about this product can be obtained
from www.lci1.com/support
MyLCI app. The app is available on iTunes
®
and iPad and also on Google Play
iTunes, iPhone and iPad are registered trademarks of
Apple Inc. Google Play and Android are trademarks of
Google Inc.
FAILURE TO FOLLOW THE INSTRUCTIONS PROVIDED
IN THIS MANUAL MAY RESULT IN DEATH, SERIOUS
INJURY, UNIT DAMAGE, OR VOIDING OF THE
COMPONENT WARRANTY.
FOR AWNINGS WITH WIND SENSORS, THE WIND
SENSOR MUST BE SHUT OFF WHEN USING THE ROOM.
IF THE AWNING SHOULD RETRACT AFTER THE ROOM
IS SET UP, DAMAGE TO THE AWNING, ROOM AND UNIT
WILL OCCUR, AS WELL AS POSSIBLE PERSONAL
INJURY. REFER TO THE AWNING OWNER'S MANUAL
FOR INSTRUCTIONS.
MOVING PARTS CAN PINCH, CRUSH OR CUT. KEEP
CLEAR AND USE CAUTION.
lippertcomponents.com
or by downloading the free
®
for iPhone
™
for Android users.
™
574-537-8900
Solera
Screen Room
Installation and Owner's Manual
(For Aftermarket Application)

Preparation

Both the Solera Family Room and Screen Room are
designed the same. The installation instructions will be the
same for both products.
NOTE: Confirm proper room size. Measure existing awning
from center of arm to center of arm. Room size must match
awning size. A smaller room cannot be installed on a
longer awning.
®

Resources Required

• 2 people
• Cordless or Electric Drill or Screw Gun
• Appropriate Drive or Drill Bits
1/4
• " Hex Head Bit
• Mallet or Hammer
• Measuring Tape
• Ladder
• Sealant
• Non-permanent method of marking
2
Rev: 01.17 - Solera
Family and
®
Family and Screen Room
®