Reading The Min/Max Values For The Temperature; Resetting All Parameters To Factory Setting; Operation; Reading The Process Value - Prosense FMM50-1002 Operating Instructions Manual

10.5.2 Reading the min./max. values for temperature
► Select [HI.T] or [LO.T] and press [Set] briefly.
[HI.T] = maximum value, [LO.T] = minimum value.
Speicher löschen:
► Select [HI.T] or [LO.T].
► Press [Set] and keep it pressed until [----] is displayed.
► Press [Mode/Enter] briefly.
It is recommended to delete the memories as soon as the unit works under
normal operating conditions for the first time.
10.5.3 Reset all parameters to the factory setting
► Select [rES], then press [Set] and keep it pressed until
is displayed
► Press [Mode/Enter] briefly.
For the factory settings please refer to the end of these instructions
We recommend recording your own settings in that table before carrying
out a reset.

11 Operation

11.1 Reading the process value

The LEDs 1-6 signal which process value is currently displayed.
The process value to be displayed as standard (temperature, flow rate) can be
→
preset. 10.4.3 Configuration of the standard display. A standard unit of meas-
urement can be defined for the flow rate (l/min, m
temperature measurement, °C or °F can be selected as standard unit of measure-
→
ment ( 10.4.2).
Further process values can be read in addition to the preset standard display:
►
Press [Set] briefly.
> The LED of the selected process value display is lit and the current process
value is displayed.
> After 15 seconds the display changes to the standard display.
[----]
→
3 /h, gpm or gph)
→ 13.
10.4.1). For
19