Parameter Setting In General; Switching Between The Menu Levels - Prosense FMM50-1002 Operating Instructions Manual

10.1 Parameter setting in general

1
Select parameter
► Press [Mode/Enter] until the
requested parameter is displayed.
2
Changing the parameter value
► Press [Set] and keep it pressed.
> Current setting value of the parame-
ter flashes for 5 s.
> After 5 s: The setting value is chan-
ged: incremental by pressing briefly
or scrolling by holding pressed.
Numerical values are incremented continuously. If the value is to be reduced: let
the display move to the maximum setting value. Then the cycle starts again at the
minimum setting value.
3
Confirm the parameter value
► Press [Mode/Enter] briefly.
> The parameter is displayed again.
The new setting value is stored.
Setting of other parameters:
► Start again with step 1.
Finishing the parameter setting
► Press [Mode/Enter] several times until the current measured value is displayed or wait
for 15 s.
> The unit returns to the operating mode.

10.1.1 Switching between the menu levels

Change to the
submenu
Back to the process
value display
16
► Press [Mode/Enter] until [EF] is displayed.
► Press [Set] briefly.
> The first parameter of the sub-menu is displayed (here: [HI.F]).