Alcatel-Lucent 7210 SAS D Service Manual page 227

IP QoS Policy Match Commands
dscp
Syntax dscp
no dscp
Context config>qos>sap-ingress>ip-criteria>entry>match
Description This command configures a DiffServ Code Point (DSCP) code point to be used for classification of packets
from the specified FC.
The no form of this command removes the DSCP match criterion.
Default none
Parameters
dscp-name — Specifies a dscp name that has been previously mapped to a value using the dscp-name
command. The DiffServ code point can only be specified by its name.
Values
dst-ip
Syntax dst-ip {ip-address/mask | ip-address netmask}
no dst-ip
Context config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description
This command configures a destination address range to be used as a SAP QoS policy match criterion.
To match on the destination address, specify the address and its associated mask, e.g., 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of this command removes the destination IP address match criterion.
Default
none
Parameters ip-address — The IP address of the destination IP or IPv6 interface. This address must be unique within the
subnet and specified in dotted decimal notation.
Values
7210 SAS D, E OS Quality of Service Guide
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15, cs2,
cp17, af21, cp19, af22, cp21, af23, cp23, cs3, cp25, af31, cp27, af32, cp29, af33, cp31,
cs4, cp33, af41, c p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef, cp47,
nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57, cp58, cp59, cp60, cp61, cp62,
cp63
ipv4-prefix: a.b.c.d
ipv4-prefix-length: 0 -- 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
Operational Commands
Page 227