Weekly Cleaning - Curtis CFB1 Service Manual

28. Prepare the tap handle assembly for attachment. Check the red rubber gasket on the back of each tap assembly for wear.
Replace if necessary. Lubricate each tap gasket with food grade lubricant. Insert the gasket into the tap hole on the bottom of
the bowl. Line up the middle pins on the handle with the mounting slots.
29. Attach the tap handle assembly. Push in with your thumb on the center of the handle until the handle assembly pops into place.
30. Reassemble and reinstall each lid and insert the light plug into the socket behind each mixing bowl.
Rinse the Unit
Before starting up the unit again after cleaning, rinse it out as follows:
31. Connect the power cord to the electrical outlet.
32. Fill the mixing bowls with clean water;
33. Turn the main power switch to the ON (|) position. Push (|) on the mixing switches for all of the mixing bowls. Make sure the
refrigeration switches are OFF (O).
34. Leave the unit on for five minutes.
35. Drain the water from each of the mixing bowls by placing a container under the tap and pulling the lever.
Reinstall the Drip Trays and Wipe Up
36. Position the drain hose in the opening
in the top of each tray. Then, insert the
tabs on the back of the drip tray into
the holes on the front of the chassis.
Push down gently to secure in place.
37. Wipe any dust or debris from the
exterior surfaces of the unit with a
damp cloth. Wipe up any spills/liquids
in the surrounding area.

Weekly Cleaning

1. Make sure the main power switch is in the OFF (O) position.
2. Lift the filter* up and out of the slot on the left side of the unit.
3. Clean the filter and the ventilation louvers on the outside of the unit with a
vacuum or soft bristled brush.
4. Replace the filter.
*Model CFB1 is not equipped with a filter.
Service Manual - Frozen Beverage Dispenser
Spring must be
between mounts
Red gasket
(lubricate)
30
Mount
Line up as
shown
Push here
28
33 35
29
Drain hose
36
Page 9