Timer Operation - Curtis CFB1 Service Manual

11. Open the control panel door (on the right side) and make sure the
main power switch is in the OFF (O) position.
12. Set the timer clock according to the
instructions below.
13. Connect the unit to a grounded,
3-prong, electrical outlet with the
appropriate amperage rating. The circuit
must be protected by a suitably rated circuit breaker. Do not use an
extension cord or any type of adapter.
14. Turn ON (|) the main power switch.
15. Clean and sanitize the unit before using it for the first time as
instructed in the CLEANING section. Verify that the unit is operating
properly according to the operating instructions.
SETTING THE TIMER CLOCK*
CAUTION:
• Set the timer only with the main power switch in the
OFF
(O) position.
• Turn the timer wheel only in the clockwise direction.
• Do not set the timer using any kind of tool.
1. With the main power switch off, turn the outer wheel on the timer
clockwise until the correct time (AM or PM) lines up with the arrow on
the clock face.
2. Turn on the main power switch to start the clock.
IMPORTANT: The clock/timer is equipped with a backup circuit
and continues to keep time for 10 to 15 minutes after power is
interrupted. If the power cord is disconnected or the main power
switch is turned off for a longer period of time, the clock will need
to be reset when power is restored.

TIMER OPERATION*

Use the timer to start the unit automatically. This feature allows you to pour
the mix in ahead of time and have the frozen beverage ready to serve at
the programmed time (unattended operation). The timer determines when
the unit is in standby (night) mode or freeze mode. In standby mode the
mixture is kept cool, but does not freeze.
The unit comes from the factory set for manual (non-timer) operation.
When all of the timer tabs are flipped outward (see diagram, right),
the timer is disabled and the unit will freeze the mixture any time the
refrigeration switch is set to ON (|).
Setting Up the Timer
1. With the main power switch off, flip the timer tabs next to the time
marks on the timer to either the standby or freeze position. The unit
will operate in the mode selected during the corresponding time
period.
2. Check to make sure the clock is set to the current time, then turn ON
(|) the main power switch.
*Models CFB2 and CFB3 only.
Service Manual - Frozen Beverage Dispenser
IMPORTANT: The unit
may not operate as
desired if the timer is not
set properly.
Main Power Switch Location
Turn outer wheel
clockwise to set
Clock Set to 9:05 PM
Timer tabs
12
9 3
6
12
9 3
6
Timer tab in
freeze position
Timer tab
in standby
(night)
position
Timer Side View
Page 3