Table of Contents
Advertisement
Using
the
Remote
Control
Using Direct Entry
1.
Turn on the component
you want tile remote to operate.
2.
Look tip tile brand and code nuh_ller(s) for the component
on tile code list on page 26.
3.
Press and hold the component
button that corresponds
to the component
you want the
remote to operate (VCR1, DVD, etc.)
4.
Enter the code Dora the code list.
5.
Release tile component
button.
6.
Press ON*OFF to see if tile component
responds
to tile remote conlnlands.
If it doesn't,
try
pressing tile component
button and then ON-OFF
again.
7.
If you get no response,
repeat these steps using the next code listed for your brand until tile
component
responds
to tile remote conlnlands.
The buttons might
operate differently
for
other components,
especially when you're
using another
eomponent's menu
system.
How to Use the Remote After You've
Programmed
It
Once the remote has been programmed
successfully,
you are ready to use it to control your
components.
To operate
the component:
1.
Press tile component
button (TV, VCR1, VCR2, DVD, AUX, or SAT-CABLE) to set the remote
to operate
the component.
2.
Press ON-OFF
to turn the component
ON or OFF.
3.
Use the remote buttons that apply to that component.
Note: If you keep pressing
buttons and nothing happens,
the remote is probably
in the
wrong *node. You must press the component
button that matches the component
you
want to operate (i.e., if you want to operate the VCR, press VCR1 on the remote control to
put the remote in VCR mode.)
Chapter
2
25
Hide quick links:
Advertisement
Table of Contents
