RCA 15491880 User Manual page 20

Connections 8. Setup
Step 3: Configuring for a VCR
1. If your 'IX' is connected to a VCR. prvss OK.
Is 8 V(3_ co_w)cted to this 1Y?
.rYeS
°No
It' it is not, high[ight No and press OK (a screen will appear reminding you
to COlmeCt your G-LINK cable to your TV and VCP..).
2. t_sc' the up anti down arrow buttons tn highligl'Jt the brand of your VCR that
_o_,,_,_._,,_,,,,.,*,,,m_, is connected to the "IX'and press OK.
'tCR_rx_ AnImcc_t _r,d _,lrgaatt_ _ In_am _¢¢_g trr0rs
.... If your brand isn't listed, highlight Xot Listed and press OK.
.
Time your VCR to channel 02. Next, turn OFF your VCR. When you
complete these steps, press OK to begin testirtg.
Important Note: When code testing ts i_1progress, don't touch your TV,,
VCR, or any o[ the remote controls for these products.
4.
Look at the front display of your VCR. If your VCR turned on automatically
and changed to channel 09, the test was successf'al. Highlight Yes and
press OK.
If your VCR didn't change to channel 09, you can either choose No or Test
this code, again.
If
you think your TV or remotes might have been touched during the test,
tune your VCR to channel 02, turn off your VCR and highlight Test this
code again.
If you don't think the test was interrupted, highlight No. Tune your VCR to
channel 02 and turn off your ¥CR. Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep h)llowing the previous instmctkms until the ¥CR finds the
correct code.
18 Chapter 1