Ketra X2 Installation Manual page 11

6. Ensure that no conductors are visible after insertion, and that no stray wires are exposed.
7. Carefully tuck wires back into wall box.
8. Mount the X2 to the wall box using supplied fasteners. Leave the fasteners snug, not fully tight.
(See Fig 5)
9. Secure Wall Plate Mount to the X2 using the supplied fasteners. (See Fig 6)
Note: If the X2's button chassis is not aligned with the wall plate mount, remove the mount and adjust
the position of the X2. Secure the wall plate mount with the fasteners when satisfied.
1 5
10. Place one serial number sticker on the back of the wall plate. The other can go on building plans or
control drawings. (See Fig 7)
11. Attach Wall Plate to Wall Plate mount. It will snap into place.(See Fig 8)
12. Energize circuit.
Note: Indicator lights will power on if unit is properly wired.
1 7
X2.D.ELV
SN: KX12345678
DC: V0216
Installation is complete.
Refer to Design Studio Software for commissioning details.
PAGE 11
I N S TA LL ATI O N
AC INPUT, NON-DIAMMING
1 6
8
770-000026-01 r08
X2.D.ELV
SN: KX12345678
DC: V0216
X2
INSTALLATION GUIDE