Related Manuals for Ketra X1
Summary of Contents for Ketra X1
- Page 1 1 ” PH I LLI PS H E AD SC R E WS DIS PL AY P OWER SU PPLY SU C TIO N CU P M IC RO FI B ER CLOTH © 2014 Ketra. Inc. All rights reserved. PAGE 1...
- Page 2 Prepare the wire for connection to wired terminal: a. Strip 8.5mm of wire for insertion into the X1 Terminal Block b. Twist the stranded wire to prevent fraying. (Tinning optional) Insert wires into Power Supply’s wiring terminal: a. Insert small flat-head screwdriver above to release clamp...
- Page 3 The X1 Touchpad communicates with Ketra’s lighting products via wireless signal. Power needs to be run directly to fixtures being controlled by the X1 Touchpad. Fixtures to be controlled by X1 Touchpad do not have to be connected to the same circuit as control signal is wireless. In the typical case of a retrofit thru-wire installation, the incoming and outgoing line connections should be tied together;...
- Page 4 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. © 2014 Ketra. Inc. All rights reserved.
Need help?
Do you have a question about the X1 and is the answer not in the manual?
Questions and answers