Topcom Twintalker 7100 User Manual page 8

8
13.11.2 Sending a call Tone
10
Press the button briefly. The call tone will be transmitted on the set channel.
13.12 Roger Beep On/Off
After the -button is released, the unit will send out a roger beep to confirm that you have
PTT
stopped talking.
To set the Roger Beep.
• Press the - button
• Press to enable (ON) or
• Press the PTT - button
standby mode.
13.13 Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press ten times. 'tO' will be displayed.
• Press to enable (ON) or
• Press the PTT - button
standby mode.
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The PMR will only receive
signals transmitted on that channel with the CTCSS/DCS code.
Dual Channel Monitor (DCM) allows you to monitor a second channel with CTCSS/DCS code.
• Press the
on the display.
• Press the
channel.
• Press the
and go to CTCSS selection. (Press the
again to go to DCS selection)
• Press the
CTCSS code or DCS code.
• Press the PTT-button
mode.
• To disable the function select "OF" when selecting the DCM
channel.
When the Dual Channel Monitor function is activated, the PMR will switch sequentially between
the standby channel + CTCSS/DCS code and the Dual Channel + CTCSS/DCS code.
5
nine times. 'rO' will be displayed.
to disable the Roger-Beep (OF).
11 to confirm your selection and return to the
disable the Key Tones (OF).
11 to confirm your selection and return to the.
5
-button eleven times," DCM OF" will flash
9 6
-button or the -button to change the
5
-button to confirm the channel selection
5
-button
9 6
-button or the -button to change the
11 to confirm and return to stand-by
13.15 Button Lock
• Press and hold the
activate the Button lock mode. The button lock icon is
displayed on the LCD Screen.
• Press and hold the
deactivate button lock
The PTT-button 11 , the
functional when the Button Lock is activated.
13.16 Stopwatch function
The Twintalker 7100 has a stopwatch that will count to 59'59''99.
• Press the
stopwatch display will appear.
• Press the
• Press the
• Press the
• Press the
deactivate the stopwatch.
13.17 Display back light
To activate the backlight of the LCD display, press any button except the PTT- button
10
button .
The LCD backlight will light up for 6 seconds.
14 Earpiece connection
The Twintalker 7100 can be used with the included earpiece.
The connector is located on the upper side of the unit
Insert the earpiece plug into the connector (2,5mm jack).
The small button on the earpiece has the same function as the PTT - button
When you use the PTT - button 11 from the Earpiece, you must also use the microphone from
the earpiece to talk into
.
Do not connect other earpieces. This may damage your device.
Twintalker 7100 Sport Pack
5
-button for three seconds to
5
-button again for three seconds
10 4
-button and the -button will still be
10
-button and hold for three seconds , the
9
-button to start the stopwatch.
9
-button to stop the stopwatch.
6
-button to reset the stopwatch to zero.
10
-button and hold for three seconds to
.
2
11
11 or the
on the unit