Topcom Twintalker 7100 User Manual page 5

Twintalker 7100 Sport Pack
10.2 Connecting the power adapter directly to the PMR
1. Connect the connector of the power adapter directly to
the Headset/Charger connection (2) of the PMR.
2. In the display you can see the charging status of the
battery. Refer to "13.2 Battery Charge Level/Low
Battery Indication" to understand the battery status
icon in the display.
It will take about 4 hours to fully charge the Li-Ion battery.
Do not short-circuit the batteries or dispose in fire. Remove the batteries
if this device is not going to be used for a long period.
Do not charge non rechargeable batteries like Alkaline batteries in the
charger. This might damage the PMR's and charger unit.
11 Description
See folded cover page - illustration 1
1. LCD display
2. Headset / charger connection
3. Antenna
4. On-off button
5. Menu button
– Enter the menu settings
6. Down button
– Decrease the speaker volume
– Select the previous value in the menu
7. Charger contacts
8. Microphone
9. UP button
– Increase the speaker volume
– Select the next value in the menu
10. Call button
11. Push to talk button PTT
12. RX LED
– Will go on when receiving a signal
12 LCD display information
See folded cover page - illustration 2
13. Scanning indication
– Displayed during scan mode
14. VOX indication
15. Dual Channel Mode (DCM) indication
16. Channel/Menu item indication
17. DCS indication
18. CTCSS indication
19. CTCSS/DCS/ Stopwatch 1/100 value / Menu option -value
20. Speaker volume indication
21. Key pad lock icon
22. Battery level indication
23. Stopwatch minutes value
24. RX icon
– Displayed when receiving
25. TX icon
– Displayed when transmitting
13 Using the Twintalker 7100
The display illustrations in next pages only show the icons or display
informations of the functions that are explained in the text.
13.1 Turning the Unit ON/OFF
To turn ON:
• Press and hold the
will "beep" and the LCD display will display the current
channel.
To switch OFF:
• Press and hold the
will "beep" and the LCD display will turn blank.
13.2 Battery Charge Level/Low Battery Indication
The battery charge level is indicated by the number of squares present inside the battery icon on
the LCD Screen.
When the battery charge level is low, the battery icon will flash and a beep will be heard to
indicate that the batteries need to be replaced or recharged.
4
- button for 3 seconds. The unit
4
- button for 3 seconds. The unit
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
5