Configuring Downstream Dsg 1.2 Settings For Advanced-Mode Dsg 1.2 - Cisco cBR Series Configuration Manual

Advanced-Mode DOCSIS Set-Top Gateway 1.2 for the Cisco CMTS Routers
Step 7
What to Do Next
Troubleshooting Tips
Refer to debug and show commands in the
Gateway Feature, on page

Configuring Downstream DSG 1.2 Settings for Advanced-Mode DSG 1.2

When the global and client configurations are set for DSG 1.2 on the Cisco CMTS, use the following procedure
to continue with DSG 1.2 downstream configurations.
Procedure
Step 1
Step 2
Step 3
Command or Action
start end ]| [priority priority ][src-ip {ipaddr
|hostname} [src-prefix-len length ]] [enable |
disable] [in-dcd {yes | no | ignore}]
Example:
Router(config)# cable dsg cfr 1 dest-ip
224.225.225.225 tunnel 1 dest-port 40 50
priority 2 src-ip ciscovideo.com
src-prefix-len 24 enable
end
Example:
Router(config)# end
Router#
29.
Command or Action
enable
Example:
Router> enable
configureterminal
Example:
Router# configure terminal
interface cable {slot /port |slot /subslot/port
}
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
Configuring Downstream DSG 1.2 Settings for Advanced-Mode DSG 1.2
Purpose
whether or not to include the classifier in the
DCD message.
When you use the ignore option, the
Note
DSG classifier is not included in the
DCD message.
Returns to privileged EXEC mode.
How to Monitor and Debug the Advanced-mode DOCSIS Set-Top
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enters interface configuration mode.
19