Installation - GE MDS SD4 Series Startup Manual

Table 1. Accessories Supplied with the Unit
Accessory
DC Power Plug,
2-pin, polarized
Radio
Configuration
Software
Start-Up Guide
Reference
Manual

INSTALLATION

There are three main requirements for installing the transceiver: ade-
quate and stable primary power, a good antenna system, and the cor-
rect data connections between the transceiver and the data device.
Figure 3 shows a typical remote station arrangement. This is followed
by step-by-step procedures for installing the transceiver and making
external connections.
05-4669A01, Rev. A
Description
Mates with power connector on radio.
Screw terminals provided for wires,
threaded locking screws to prevent
accidental disconnect.
PC software used for setting the basic
operating parameters of the radio.
Brief instructions for initial setup and
commissioning of the radio.
Full technical information for the
radio, including a complete
description of software commands.
MDS SD4 Startup Guide
Part Number
73-1194A39
03-3156A01
05-4669A01
05-4670A01
3