Table of Contents
Advertisement
♦ Update Firmware by USB
Note: Please keep this guide carefully to update the firmware without fail. Unplugging of DC
power during the uploading process will result failure of boot loader in TX and RX.
(1) Copy "IPKVM-500.bin" to an USB memory stick.
(2) Insert the USB memory stick to any USB A ports on the selected TX or RX.
(3) Unplug and plug the DC power to the power jack of selected device. (IPKVM-500-E or D)
(4) Please wait until LED blinking stops and the device is rebooted. It takes about 3 minutes for
TX and 5 minutes for RX. (Do not unplug DC power until it finished)
(5) Remove the USB memory stick from the device (IPKVM-350-E or D)
12. IPKVM-500-ED Connection & Operation
1) GUI
Connection can be managed on a GUI of each client (RX)
When TXs and RXs are in the TCP/IP network, you can see all hosts (TXs) with each IP
addresses and device information on the GUI of a client (RX).
▶Press a hotkey to enter into the GUI menu on the connected keyboard
- Ctrl + Alt + Shift + Backspace
- Ctrl (right) + Enter
- Ctrl (right) + ESC
▶ Press a hotkey to exit from the GUI on the connected keyboard
- ESC key
♦ IP Address/Device Information and status will be shown as below.
Note: You can select and connect to an available TX, but please remind that with blocking
function 'disabled' in multicast mode(1:N), many client may access to a host with a
keyboard and mouse at local and remote site. For details, please refer to Page 18,
multicast streaming and blocking function.
2) Connection & Operation
♦ Connection
(1) Press 'hotkey' to enter into a GUI of a client on the keyboard.
(2) Select an IP of available TX.
(3) Press [Enter] button on the keyboard or click [Connect] button on the GUI.
♦ Switching to another host (TX)
(1) Press 'hotkey' to enter into GUI menu if you want to connect another host.
(2) Select one of available hosts.
(3) Press [Enter] on the keyboard or click [Connect] button on the GUI.
(4) Press [ESC] key on the keyboard if you want to return to current image screen without
switching action.
♦ Dis-connection
(1) Press 'hotkey' to enter into a GUI of a client on the keyboard.
(2) Click [Disconnect] button on the GUI.
- 17 -
Advertisement
Table of Contents
