Table of Contents
Advertisement
♦ EDID write from default EDID data to all hosts (recommended)
After you check the default EDID data between HDMI and DVI on the top right, you can write
the default EDID data to all TXs or selected one.
Default EDID value is HDMI on the product.
(1)
Select Default HDMI or Default DVI.
Click 'EDID write' button (all hosts recommended).
(2)
7) Update Firmware
♦ Update Firmware by PC Program (Remote Manager)
(1) Click 'Search' button to find devices to upgrade on the network or directly with PC
(2) Select a device to upgrade on the left list window.
Note: User can see the present Firmware version of the selected device on the right side
window.
(3) Please check the IP address and Gateway of the PC. It must have same IP class with the all
of TXs and RXs.
Note: If IP address class and Gateway of PC is different from the selected device, change IP
address and Gateway of PC on the control panel.
(4) Click 'File Open' button. Search and select a firmware file.
(5) Click 'Upload' button.
(6) Please wait until LED blinking stops and then the device will be rebooted.
Note: You can see a pop up message when it completes. It takes about 3 minutes for TX and
5 minutes for RX.
- 15 -
Advertisement
Table of Contents
