Page 1
AB7500 User Guide Dual Pocket Mixed Bill Counter...
Page 2
Thank you for purchasing this AccuBANKER product. We recommend reading all information in the user guide to become familiar with this product. AccuBANKER and its logo are registered trademarks of Hilton Trading Corp. All Rights Reserved.
1- Introduction The AB7500 is a double pocket bill counter designed to accelerate the cash counting process, as it does not stop its operation when a suspicious bill is detected; instead it is sent directly into the rejection pocket. The final count result shows the total value as well as the number of bills involved in the count.
3- Control Panel Description AccuBANKER AB7500 BATCH MODE CURRENCY PRINT FACE/ORT TOTAL DISPLAY START ACCEPT STOP - Up / Down / Left / Right BUTTONS: Used to move the cursor in the configurations menu IMPORTANT : When there are bills in the rejection tray, the user can know the cause of the bill rejection by pressing the key .
Page 5
- ADD: Activates ADDING function - TOTAL: Shows the TOTAL VALUE COUNT - DISPLAY: Displays the count details - C: Erases data on the screen or erases error reports - ACCEPT: Confirms any changes made in “Configurations” screen as well as count results - START / STOP: Starts and Stops counting operations - SET: Enters the “Configurations”...
Page 6
4- DUAL USER; NOT AVAILABLE 5- AUTO-START Used to set the unit to MANUAL start mode, or to vary the machine’s start time after the first notes are detected by the Hopper sensor. 6- REPEAT START Used in BATCH mode to set the unit in AUTO / MANUAL mode during the batching process.
13- CNT MODE Enables / Disables the CNT (basic count) mode. 14- CNT CF CHECK Enables / Disables the verification of banknote security features in CNT (Basic Count) mode. 15- ASSIGN OPERATOR: NOT AVAILABLE. 16- CURRENCY CF In this section the operator configures the sensitivity of the detection sensors of the various banknote security verification functions.
20-21- PORT L RATE / PORT R RATE Configures the communication speed of the serial port (9600 / 19200 38400 / 115200). PRINTER: Data bits: 8 / Stop bits: 1 / Parity: None TERMINAL (PC) : Data bits: 7 / Stop bits:1 / Parity: None 22- CIS SELECT Activates / Deactivates the CIS sensor in CNT mode (Basic Counting) 23- SELECT DIGIT...
29- PRINTER CONTROL - MODES a- MANUAL: Press the PRINT key to print. b- AUTO 1: Print automatically every time the stacker is emptied. c- AUTO 2: Prints automatically each time the hopper and stacker are emptied. d- REPEAT: 2- Duplicates the printout / 3- Triplicates the printout e- LINES: Number of blank lines after each printed item f- LIST: Shows in the printing all denominations, or only the denominations detected in the count.
Page 10
5- Bill Rejection Codes Descriptions During the count, suspicious bills are rejected directly into the rejection pocket. To determine the specific cause of rejection, simply press the key and the display will show the rejection details using the following error codes described bellow. •...
6- Error Codes Descriptions Error messages reported during unit’s operation • SKEW: Bill entered skewed • TYPE 2: Rejected because BATCH is full • REJ DENO: Rejected by denomination • JAM PS1: PS1 Sensor obstructed, open top cover and remove the jammed bill, press C to continue •...
6- Periodic Maintenance Follow the recommendations below to minimize possible errors during the operation of the unit and extend the life of the unit. 6.1 Daily Maintenance Proceed with the following routine each day after unit’s final use a. Turn OFF the unit. b.