Operation; Safety Instructions - Power Craft PBS-950 User Manual & Warranty

Operation

Choice of the sand-paper
Coarse sand-paper (grain 60) removes in general the bigger part of the
material and fine sand-paper is used for the finishing. If the surface is not
even, then start with rough sand-paper. Further you use middle coarse sand-
paper(grain 80) to remove the scratches left behind by the coarse sand-paper
and finally you take fine sand-paper (grain 120) for the finishing.
Operating instructions
Make sure that the machine has reached its full speed before placing the ma-
chine on the work piece. This will prevent an overload of the machine.
For sanding wood, place the machine approximately 15° out of the grains of
the wood. Move the belt sander continuously over the work piece, in a back
and forth motion.
• Do not bend the sanding belts
• Do no use the same sanding belt for sanding wood and metal
• Do not bring too much pressure to your machine, this will only delay the
sanding.
Troubleshooting
In case the belt sander does not work well, we give you some possible causes
and solutions.
1. The electromotor gets hot
• The cool ventilation slots in the motor are blocked with dirt.
Clean the cool ventilation slots.
• The motor is defect.
Contact the adress on the warranty card.
2. The connected machine does not work
• Interruption in the mains connection.
Check mains connection for fracture.
Contact the adress on the warranty card.
3. The dust is not absorbed
• This can be caused by a stopped up dust extraction
Clean your dust collection opening
Repairing of electric appliances may be carried out only by experts.
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
Model Number: PBS-950
bSM6019 Ma-Gb # 0806-24.indd 13-14

Safety instructions

The following symbols are used in these instructions:
Read instructions carefully.
Conformity with the relevant EU safety directives.
Class II machine - double insulation - earth connection not required.
Danger of life and risk of injury as well as risk of damage to the
machine in case of non-adherence to the safety instructions in these
instructions of use.
Danger of electric shock.
Remove the plug from the mains socket.
Wear a dust mask. Working with wood, metals and other materials
may produce dust that is harmful to health. Do not work with
material containing asbestos!
Wear eye protection.
Faulty and/or discarded electrical or electronic machines have to be
collected at the appropriate recycling locations.
Variable rotational speed
General safety instructions
Caution! Read all instructions. The non-observation of the instructions
mentioned below may cause an electric shock, fire and/or severe injuries. The
term "electric tool" mentioned below refers to mains-operated electric tools
(with power cord) and to rechargeable electric tools (without power cord).
Keep these instructions for use in a safe place.
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
14 Model Number: PBS-950
7
6/25/08 9:19:00 AM