Operation - Power Craft PBS-950 User Manual

UK
Environment
In order to prevent the machine from damage during transport, it is delivered in a sturdy
packaging. Most of the packaging materials can be recycled. Take these materials to the
appropriate recycling locations.
Take your unwanted machines to your local Ferm-dealer. Here they will be disposed of in an
environmentally safe way.
Warranty
For the conditions of guarantee, please refer to the separately provided guarantee card.
CE DECLARATION OF CONFORMITY (UK)
We declare under our sole responsibility that this product is in conformity with the following
standards or standardized documents
EN60745-1, EN60745-2-4, EN55014-1,
EN55014-2, EN61000-3-2, EN61000-3-3
in accordance with the regulations.
from 01-03-2005
ZWOLLE NL
W. Kamphof
Quality department
It is our policy to continuously improve our products and we therefore reserve the right to
change the product specification without prior notice.
8
98/37/EEC
73/23/EEC
89/336/EEC
instructions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating plate.
The machine is double insulated in accordance with EN-50144; therefore no earth
wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
completely.
Special safety precautions
• If you are working with the sanding machine, wear always ear protectors and dust mask.
• The sanding machine is not suitable for wet sanding.
• Check if the switch is not in position "ON", before you connect the mains plug to the mains
voltage.
• Keep the mains lead always away from moving parts of the tools.
• Use safety glasses, especially when you sand above your head.
• Do not bring pressure to your machine, this will only delay the sanding.
The dust that is produced while working can be detrimental to health, inflammable or
explosive. Suitable safety measures are required. Always wear suitable safety
equipment, for example a dust mask, and use the dust bag.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes and verticiliosis in the collector.
• Interruption of the mains plug, mains lead or mains lead damage.
• Defect switch
• Smoke or stench of scorched isolation

3. OPERATION

Always observe the safety instructions and applicable regulations.
Choice of the sand-paper
Coarse sand-paper (grain 50) removes in general the bigger part of the material and fine sand-
paper is used for the finishing. If the surface is not even, then start with rough sand-paper.
Further you use middle coarse sand-paper(grain 80) to remove the scratches left behind by the
coarse sand-paper and finally you take fine sand-paper (grain 120) for the finishing.
Powercraft Powercraft
2 . When using a cable reel always unwind the reel
UK
5