Error In Transferring The Data Record Analog Input - Siemens ET 200SP Manual

Parameter data record
A.3 Error in transferring the data record analog input
A.3

Error in transferring the data record analog input

Error transferring the data record
The module always checks all values of the data record to be sent. The module applies the
values from the data record only when all values have been transmitted without errors.
The WRREC instruction for writing data records returns corresponding error codes when
errors occur in the STATUS parameter, see also the description of the "STATUS" parameter
in the STEP 7 online help).
The following table shows the module-specific error codes and their meaning for parameter
data record 128.
Error code in STATUS parameter
(hexadecimal)
Byte 0 Byte 1 Byte 2
DF 80 B0
DF 80 B1
DF 80 B2
DF 80 E0
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
36
Meaning
Byte 3
xx Number of the data record un-
known.
xx Length of the data record incorrect. Enter a valid value for the data record length.
xx Slot invalid or cannot be accessed. •
xx Wrong version or error in the
header information.
01 Reserved bit set
02 Invalid diagnostics enable bit set
for operating mode.
05 Invalid coding set for measuring
range / measurement type.
08 Invalid coding set for interference
frequency suppression / integration
time.
09 Invalid coding for smoothing.
Solution
Enter a valid number for the data record.
Check the station to determine whether
the module is plugged or pulled.
Check the assigned values for the pa-
•
rameters of the WRREC instruction.
Correct the version, length and number of
parameter blocks.
Check the parameters of the module.
Check the parameters of the module.
Check the parameters of the module.
Check the parameters of the module.
Check the parameters of the module.
Analog Input Module AI 4xU/I 2-wire ST (6ES7134-6HD01-0BA1)
Manual, 12/2017, A5E03572832-AD