Start Up The System - Cisco TelePresence MX800 Installation Manual
Single monitor with single/dual camera
on a free standing floor stand or a floor stand secured to the wall
Hide thumbs
Also See for TelePresence MX800:
- Replacement manual (47 pages) ,
- Installation manual (30 pages) ,
- Spare parts (24 pages)
Advertisement
Installation guide for Cisco TelePresence MX800 - Floor stand
7
Start up the system
•
Remove the protection foil from the display.
•
Make sure the camera(s) can move freely.
•
Insert the network and power cables into the wall outlets.
•
Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up
may include automatic software upgrade and restart of
Touch 10 and camera(s).
•
Follow the instructions on the Touch controller.
Cisco Spark: To find more information on how to
get started with Spark registered systems, visit
http://help.ciscospark.com
articles for room systems.
Other services: For further information on set-up and
configuration, download the Getting Started Guide from the
Cisco web site,
http://www.cisco.com/go/mx-docs
78-100219-02A0 | JUNE 2016 | © 2016 Cisco Systems, Inc. All rights reserved.
and look for Getting Started
Page 13
http://www.cisco.com/go/mx-docs
Advertisement
