After Changing Wheels - Toyota HILUX 2007 Owner's Manual

Type C
11. Reinstall the wheel ornament.
Type A and B-
Put the wheel ornament into position. And
press hand firmly on one side of wheel
ornament and then firmly tap the other
side around the edge of wheel ornament
with the heel of your hand to snap into
place.
Type
C-
Push the wheel ornament into the center
hole.
212
&
CAUTION
• Take due care in handling the orna·
ment to avoid unexpected personal
injury.
• Do not attach a heavily damaged
plastic wheel ornament. It may fly
off the wheel and cause accidents
while the vehicle is moving.
-After changing wheels
12. Check the air pressure of the re-
placed tire.
Adjust the air pressure to the specification
designated on page 271. If the pressure
is lower, drive slowly to the nearest ser-
vice station and fill to the correct pres-
sure.
Do not forget to reinstall the tire inflation
valve cap as dirt and moisture could get
into the valve core and possibly cause air
leakage. If the cap is missing, have a new
one put on as soon as possible.
13. Restore all the tools, jack and flat
tire securely.
As soon after changing wheels as pos-
sible, tighten the wheel nuts to the torque
specified on page 271 with a torque
wrench. Have a technician repair the flat
tire and replace the spare tire with it.
This is the same procedure for changing
or rotating your tires.