Advertisement
liquids are present continuously or for long periods of time under normal operating conditions);
· Zone 1 classified location (areas where ignitable concentrations of flammable gases, vapors or
liquids are likely to exist under normal operating conditions);
· Class I, Division 2 or Zone 2 classified locations (areas where ignitable concentrations of flammable
gases, vapors or liquids are not likely to exist under normal operating conditions);
· Class II, Division 1 classified locations (areas where ignitable concentrations of combustible dust
can exist all of the time or some of the time under normal operating conditions);
· Class II, Division 2 classified locations (areas where ignitable concentrations of combustible dust are
not likely to exist under normal operating conditions);
· Class III, Division 1 classified locations (areas where easily ignitable fibers or materials producing
combustible flyings are handled, manufactured or used.
· Class III, Division 2 classified locations (areas where easily ignitable fibers are stored or handled);
· Zone 20 classified locations (areas where ignitable concentrations of combustible dust or ignitable
fibers/flyings are present continuously or for long periods of time under normal operating condi-
tions);
· Zone 21 classified location (area where ignitable concentrations of combustible dust or ignitable
fibers/flyings are likely to exist under normal operating conditions);
· Zone 22 classified locations (areas where ignitable concentrations of combustible dust or ignitable
fibers/flyings are not likely to exist under normal operating conditions).
1. Please check that your HEATSCOPE® radiant heater and accessories are complete and not damaged.
In special take care of the glass holders of the model range VISION, which hold and surround the glass
ceramic front screen. Press the holders carefully back in position, untill they click into place again.
If the housing or reflector is deformed/damaged or the heating element is broken, do not use the
HEATSCOPE® unit. Please contact the vendor or the manufacturer.
The cable must not be crushed, squeezed or damaged.
If the unit or accessories show signs of defects, cracking, breakage or other damage or if the industrial
glass ceramics screen is damaged, discontinue use and have them repaired. In this case, disconnect the
unit from the power supply, return it to the manufacturer or dispose of it. The unit should be labelled
accordingly to prevent it being reconnected.
2. For installation use only the supplied accessories or original accessories approved by the manu
facturer. The power cable or other components of the HEATSCOPE® radiant heater may only be
replaced by a professional servicing company enlisted by the manufacturer. Before starting the
installation, you must ensure that the operating voltage corresponds to that stated on the nameplate
of the HEATSCOPE® or accessories. Note that depending on the currently available supply voltage
the actual power of the device may change as well as the emitted power as a result of environmental
influences.
3. HEATSCOPE® heaters together with all available accessories feature IP protection class IPX4 tested
Phone: 001-310-9295333-1001 · Fax: 001-310-7335070 · E-Mail: info@greenchance.net · www.greenchance.net
A M B I E N T H E A T I N G S O L U T I O N S
US
Advertisement
