Maintenance - Makita DA3000R Instruction Manual

MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
0
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to
the limit mark. Keep the carbon
brushes clean and free to slip in the
holders. Both carbon brushes should be
replaced
a t
the same time. Use only iden-
tical carbon brushes.
L i m i t mark
s
Fig.
f
Use
a
screwdriver to remove the brush
holder cap
as
shown in the figure.
Fig. 7
V
Carbon brush
Fig. 8
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
7