Installing The Power Elevating Legrests; Removing The Power Elevating Legrests - Invacare Formula Owner's Operator And Maintenance Manual

Cg powered seating tilt recline elevate tilt/recline

Hide thumbs Also See for Formula:

Table of Contents

SECTION 6—FRONT RIGGINGS

Installing the Power Elevating Legrests

1. Turn power legrest to side (open footplate is perpendicular to wheelchair)

(Detail "A").

2. Insert the mounting pin of power legrest into the mounting hole of the seat frame

(Detail "A").

NOTE: Make sure the legrest sits flush on the seat frame.

3. Rotate the power legs toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4. Repeat STEPS 1‐3 for the opposite legrest.

5. Connect power legrest connector to jumper cable (Detail "B").

1. Disconnect power legrest connector from jumper cable.

2. Push legrest release handle and swing legrest to the outside of the wheelchair.

3. Lift up on powered legrest and remove from wheelchair.

4. Repeat STEPS 1‐3 for opposite power legrest.

DETAIL "A"

Mounting Pin

Mounting

Hole

Legrest Release

Handle

FIGURE 6.21 Installing/Removing the Power Elevating Legrests

Formula™CG Powered Seating

Calf Pad

Jumper

Cable

Footplate

Power

Legrest

Connector

DETAIL "B"

Part No 1143155

Table of Contents