Advertisement
QQ
3 7 63 1515 0
UPGRADE FW
(1) Prepare a FW disc
The files necessary for DPC-7.7 are as follows.
multi_m.ver
multi.ver
sardonyx.f16
Store these 3 and also about 40MB of files (total, WAVE, MP3 etc.) in a CD-R in "Disc-at-once" mode.
(2) Check Version in advance
Hold down [Display] and then press [Stop] to display Version of System Microprocessor.
Press [Display] twice and see the version shown on OSD.
Make sure that the existing version is shown in "Release Version" column at the top of the list.
Sample: "IE-060725A(H--1------)"
"H" confirms a HDCP key has been loaded.
The 4th digit from the left "1" shows Region.
In case of "----------" or "H-9------", the unit needs board replacement.
(3) Write the FW
1.Load the FW disc in Tray 1 to read it.
On the OSD, the following messages are shown.
Farm Upgrade
Erase and program
Start [Cancel]
TE
L 13942296513
"Cancel" is highlighted as cursor position.
On the front display, "VERUP NO" is shown.
2.Change from "Cancel" to "Start" with Left/Right cursor on Remote Controller or [|<<]/[>>|] key on the unit.
See "VERUP YES" is shown on the front display.
Press [Enter] on Remote Controller or [Play] on the body to start FW writing.
Firmware Upgrade
Programming, please wait...
Do not switch the player off!
On the front display, "DISC READ" is shown.
After reading is finished,
"FLASHWRITE" is shown on the front display and then Tray is opened.
Take the FW disc out.
3. The message has gone from the front display and Tray is closed.
This is the end of FW writing.
If the display does not change for 5 minutes, try FW writing (3) again after turning off and on.
4. Confirm Version after FW writing
Power off and on.
Hold down [Display] and then press [Stop] to show Version of System Microprocessor.
www
Press [Display] twice and see the version shown on the OSD.
Make sure that the correct version is shown in "Release Version" column at the top of the list.
Sample: "IE-060725B(H--1------)"
.
"H" confirms a HDCP key has been loaded.
The 4th digit from the left "1" shows Region.
In case of "----------" or "H-9------", the unit needs board replacement.
http://www.xiaoyu163.com
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
Q Q
3
6 7
1 3
1 5
co
.
9 4
2 8
0 5
8
2 9
9 4
2 8
m
DPC-7.7
9 9
9 9
Advertisement
