Razor E125 Owner's Manual page 13

TROUBLESHOOTING GUIDE
Problem
Sometimes the scooter
doesn't run, but other
times it does
Charger gets warm
during use
Scooter does not stop
when applying the brake
Scooter makes loud
noises or grinding
sounds
Need Help? Need Help? V V V isit Need Help?
isit isit our web site
oll-free at 866-467-2967 866-467-2967 Monday - Friday 8:00 AM - 866-467-2967
or or or call call call t t t oll-free at oll-free at
E_Series_Manualv10.indd 13
Possible Cause
Brakes are not adjusted properly
Loose wires or connectors
Motor or electrical switch
damage
Normal response to charger use
Brakes are not adjusted properly
Chain is too dry
Brake rotor is dragging on brake
pads
for updates and a list of authorized service centers at at at www.razor.com
our web site for updates and a list of authorized service centers our web site for updates and a list of authorized service centers
Monday - Friday 8:00 AM - 5 5 5 :00 Monday - Friday 8:00 AM -
Solution
Refer to adjusting the brakes instructions on page 4.
Check all wires around the motors and all connectors to make sure
they are tight.
Contact your local Razor authorized service center for diagnosis and
repair.
No action required. This is normal for some chargers and is no cause
for concern. If your charger does not get warm during use, it does not
mean that it is not working properly.
Refer to adjusting the brakes instructions on page 4.
Apply a lubricant such as 3 in 1
Use your fi ngers to twist the caliper adjuster in either direction until
rotor is centered between pads.
:00 PM :00 PM Pacifi c PM Pacifi c Pacifi c T T Time.
12
TM TM
or Tri-Flow to the chain.
www.razor.com www.razor.com
ime. ime.
3/10/06 2:11:11 PM