Advertisement
180X & 22XX
Series
INTEGRA TED POWER SYSTEM
operation manual
Introduction:
Thank you for purchasing Hitec's Energy Propel integrated Power System. Featuring a high
performance, high efficiency brushless motor integrated with our Energy Rotor electronic speed
control! This combination creates an easy straighforward installation and clean wiring layout for
your multi-rotor
Connecting Your Motor:
1. Connect the power wires from the Motor to the power distribution board or battery.
2. Connect the signal cable to the flight controller according to the instruction.
Note: The red wire from the Motor should connect to the Positive + and black to the Negative (-)
side of the Power Distribution Board.
Black
-
-
-
Power
Power Wires
Distribution
Battery
Red
Board
+
+
+
Signal Wire
(white & black)
Energy Propel
Motor
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HITEC Energy Propel 1806/18
Summary of Contents for HITEC Energy Propel 1806/18
- Page 1 Introduction: Thank you for purchasing Hitec’s Energy Propel integrated Power System. Featuring a high performance, high efficiency brushless motor integrated with our Energy Rotor electronic speed control! This combination creates an easy straighforward installation and clean wiring layout for...
- Page 2 65.5 g ONE YEAR LIMITED WARRANTY: For a period of two years from the date of purchase HITEC RCD USA, INC. shall REPAIR OR REPLACE, at our option, defective equipment covered by this warranty, otherwise the purchaser and/or consumer is responsible for any charges for the repair or replacement of the product. This warranty does not cover cosmetic damages and damages due to acts of God, accident, misuse, abuse, negligence, improper installation, or damages caused by alterations by unauthorized persons or entities.
Need help?
Do you have a question about the Energy Propel 1806/18 and is the answer not in the manual?
Questions and answers