HITEC ZIPPER Operator's Manual
  1. Manuals
  2. Brands
  3. HITEC Manuals
  4. Toy
  5. ZIPPER
  6. Operator's manual
HITEC ZIPPER Operator's Manual

HITEC ZIPPER Operator's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OPERATION MANUAL Ver 1.0
www.hitecrcd.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZIPPER and is the answer not in the manual?

Questions and answers

Related Manuals for HITEC ZIPPER

Summary of Contents for HITEC ZIPPER

  • Page 1 OPERATION MANUAL Ver 1.0 www.hitecrcd.com...

  • Page 2: Table Of Contents

    SECTION 1 INTRODUCTION Thank you for purchasing the Weekender Zipper radio control airplane. With its durable EPO foam con- struction and aileron/elevator three-channel control, this sporty aerobatic plane is a great fit for novice/ intermediate pilots. The preinstalled brushless motor, speed control and servos will have you in the air in a flash.

  • Page 3: Warnings And Safety Instructions

    6+ minute runtimes with recommended battery ITEMS REQUIRED TO READY THIS MODEL FOR FLIGHT The Weekender Zipper is a Plug and Play-type model where additional items are required for operation. The items listed below are needed to fly: • 6-Channel Radio and Receiver •...

  • Page 4: Parts Layout And Listing

    PARTS LAYOUT AND LISTING Note: Before assembly, it is important that you remove the parts from the packaging and check to make sure that all the parts are included and that they are in good condition. A. Fuselage Assembly (includes installed Motor, ESC and Elevator Servo) Main Wing C.
  • Page 5 Step 2 Step 2: Main Wing Assembly Install the wing by sliding the tab on the front of the wing into the fuselage while guiding the servo leads through the hole. Insert the 2.0 x 16mm screw and tighten until snug. Step 3 While not necessary, you can apply a small amount of CA glue to hold the...

  • Page 6: Preparing For Flight

    Step 6: Balancing Your Model Step 6 Check the center of gravity (CG) on your model by balancing it on your fingers.The CG should be at about the same place as the servo leads on the bottom of the wing. You can adjust the CG by moving the battery forward or backwards.

  • Page 7: Service And Support

    Hitec RCD USA, Inc. or its authorized agents. Hitec RCD USA, Inc. is not responsible for loss of use of the Weekender by Hitec model, or other incidental or consequential damages. Under no circumstances shall the Manufacturer or any of its representatives be held liable for injury to persons or property damage resulting from the assembly of the product or from the use of the final user assembled product.

Table of Contents