Cessna 150 STANDARD Service Manual page 54

150 series 1969 thru 1976
Hide thumbs Also See for 150 STANDARD:
Table of Contents

Advertisement

A
15067199 THRU 15071098
F150-0220 THRU F150-0559
1.
Retainer Strip
2. Anchoring Strip
3. Headliner
4. Wire Bow
5. Zipper
6. Hook
7. Window Retainer
8. Speaker Grill (1970 models)
3
REFER TO SECTION 16 FOR
CONSOLE INSTALLATION
B
15071099 AND ON
F150-0560 AND ON
A15000001 AND ON
FA15000001 AND ON
NOTE
Beginning with 1971 models the radio speaker
is located in the center overhead console.
Figure 3-7. Cabin Headliner
NOTE
The lightweight soundproofing panels are
held in place with industrial rubber cement.
6. Reverse preceding steps for installation.
Before installation, check all items concealed by
headliner for security. Use wide cloth tape to
secure loose wires to fuselage and to seal openings
in wing roots. Straighten tabs bent during removal
of headliner.
7. Apply cement to inside of skin in areas where
soundproofing panels are not supported by wire bows
and press soundproofing in place.
8. Insert wire bows into headliner seams and se-
cure two bows at rear of headliner. Stretch material
along edges to properly center, but do not stretch it
tight enough to destroy ceiling contours or distort
wire bows. Secure edges of headliner with metal
teeth.
9. Work headliner forward, installing each
wire bow in place with metal tabs. Wedge ends of
wire bows into the retainer strips. Stretch headliner
just taut enough to avoid wrinkles and maintain a
smooth contour.
3-12
Change 3
10. When all bows are in place and fabric edges
are secured, trim off excess fabric and reinstall
all items removed.
b. Detail B.
1.
Remove sun visors, all inside finish strips
and plates, overhead console, upper doorpost shields
and any other visible retainers securing headliner.
2. Remove molding from fixed windows.
3. Remove screws securing headliner and care-
fully take down headliner.
4. Remove spun glass soundproofing panels
above headliner.
NOTE
The lightweight soundproofing panels are held
in place with industrial rubber cement.
5. Reverse preceding steps for installation.
Before installation, check all items concealed by
headliner for security. Use wide cloth tape to secure
loose wires to fuselage and to seal openings in wing
roots.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents