Cessna 150 STANDARD Service Manual page 122

f. After cable is routed in position, install pulleys
and cable guards. Ensure cable is positioned in
pulley groove before installing guards.
g. Rig system in accordance with applicable para-
graph in this section, safety turnbuckles and re-
install all items removed in step "a".
8-14. RIGGING. (Refer to figure 8-1.)
NOTE
An inclinometer for measuring control
surface travel is available from Cessna
Service Parts Center. Refer to figure
6-4.
a. Locate neutral position of elevators by stream-
lining elevators with stabilizer.
SHOP NOTES:
8-6 Change 3
b. Place an inclinometer on one elevator and set
to zero.
c. Adjust elevator stops (6) to attain travel speci-
fied in Section 1.
d. Remove seats, upholstery and access plates as
necessary for access to turnbuckles (10).
e. Adjust cables to 30
±
10 pounds tension by
tightening turnbuckles (10). Ensure control "Y"
does not contact instrument panel in full-up position
or firewall in full-down position.
f. Safety turnbuckles and reinstall all items re-
moved in step "d".
IWARNING'
Be sure elevators move in correct direc-
tion when operated by control wheel.