Raypak 260-401 Installation And Operating Instructions Manual page 20

A. This heater has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the heater
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's telephone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in, move or turn the gas
control knob or lever. Never use tools. If the knob
or lever will not push in, move or turn by hand, don't
try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or
explosion.
D. Do not use this heater if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the heater and to replace any part of
the control system and any gas control which has
been under water.
FOR STANDING PILOT MODEL WITH
ROBERTSHAW GAS VALVE, ON/OFF OPERATION
1. STOP! Read the safety information above.
2. Set the tankstat on the lowest setting.
3. Turn OFF all electric power to the heater.
4. Remove heater door panel.
5. Push in gas control knob slightly and turn clockwise
to "OFF".
GAS CONTROL
KNOB SHOWN
IN "OFF" POSITION
GAS INLET
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If your smell
gas, STOP! Follow "B" in the safety information
above on this label. If you don't smell gas, go to the
next step.
7. Locate pilot mounted on the right side of the burner
drawer, right of first burner.
8. Turn knob on gas control counterclockwise
to "Pilot".
Fig.# 8083.2
HONEYWELL PILOT
9. Push in control knob all the way and hold in,
immediately light the pilot with a match. Continue
to hold control knob in for about one minute after the
pilot is lighted, release knob and it will pop back up.
Pilot should remain lighted. If it goes out, repeat
steps 4 through 8.
* If knob does not pop up when released, stop
and immediately call your service technician or
gas supplier.
* If the pilot does not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
10. Stand to the side of the heater and turn the gas
control knob counterclockwise to "ON".
11. Replace heater door.
12. Turn "ON" all electrical power to the heater.
13. Set the tankstat to the desired setting.
FOR STANDING PILOT MODEL WITH HONEYWELL
GAS VALVE, ON/OFF OPERATION
1. STOP! Read the safety information.
2. Set the tankstat to the lowest setting.
3. Turn Off all electrical power to the heater.
4. Remove heater door panel.
5. Turn gas control knob clockwise to "OFF".
GAS CONTROL
KNOB SHOWN
IN "OFF"
POSITION
GAS INLET
20
Fig.# 8041.2
ROBERTSHAW PILOT