Internet - AT&T MF279 User Manual

Internet

Problem Possible Solution
Can't access • Make sure your AT&T Wireless Internet device is powered on. Slide
the Internet
• For Wi-Fi: Make sure your AT&T Wireless Internet device is located
• For Ethernet: Make sure the Ethernet cable is securely inserted
• Move the AT&T Wireless Internet device to an area with sufficient
• Make sure the Wi-Fi
• Check the following on the AT&T Wireless Internet Manager
the On/Off switch to the ON position. The Power
turn solid green.
in the general area of your Wi-Fi enabled device(s). Check that
your device is connected to the AT&T Wireless Internet device's
Wi-Fi network (e.g., ATT-WI-XXXX) and that you are using the
correct Wi-Fi password.
into the Ethernet port on the back of the AT&T Wireless Internet
device and your computer (or other device).
network signal (three [3] to four [4] bars).
AT&T Wireless Internet device as follows: Slide the On/Off switch
to the OFF position. Then slide the On/Off switch to the ON
position; the Power
(http://att.wirelessinternet):
– Under Settings
is set to "Enable"
– Under Settings
"ATT Nextgenphone"
– Under Settings
is not set to block your device's IP and MAC address.
light is on. If it is not, restart your
light should turn solid green.
Wi-Fi Basic: Broadcast Network Name (SSID)
Network APN: Profile Selection is set to
Firewall MAC/IP/Port Filtering: The firewall
light should
31