Philips FC8802 User Manual page 14

English
14
Problem
The robot does
not work and the
dust
compartment
indicator lights up
continuously.
The robot starts
to move
backwards during
cleaning or just
after it was
switched on. The
warning indicator
flashes quickly.
The warning
indicator flashes
quickly.
The robot does
not clean
properly.
Cause
The dust container
compartment cover is
not present or is not
closed properly.
The dust container is
not present.
The bumper of the
robot is stuck.
One or both wheels
are stuck.
One or both side
brushes are stuck.
The bumper is stuck.
The robot was lifted
while it was cleaning.
The bristles of one or
both side brushes are
crooked or bent.
The filter in the dust
container is dirty.
The suction opening
in the bottom is
clogged.
The front wheel is
jammed with hair or
other dirt.
Solution
When the dust container compartment cover is not
present or is not closed properly, the robot does not
work as a safety precaution. Make sure you place the
dust compartment cover on the robot properly (see
chapter 'Before first use', section 'Inserting the
rechargeable battery').
Place the dust container in the dust container
compartment properly. Make sure you close the dust
container compartment cover properly.
If the robot manages to free its bumper by moving
backwards, the warning indicator stops flashing and
the robot starts cleaning normally. If the robot does
not manage to free its bumper, switch it off and lift it
so that its bumper comes free. Then switch on the
robot again.
Press the on/off switch to switch off the robot.
Remove the fluff, hair, thread or wire that is caught
around the wheel suspension.
Clean the side brushes (see chapter 'Cleaning and
maintenance', section 'Cleaning the side brushes').
Press the on/off switch to switch off the robot. Lift
the robot so that its bumper comes free.
Press the on/off switch to switch off the robot. Place
the robot on the floor. Then press the on/off switch
to make the robot resume cleaning normally.
Replace the side brushes (see 'Replacing the side
brushes' in chapter 'Replacement' and chapter
'Ordering accessories').
Clean the filter in the dust container with a brush
with soft bristles (see chapter 'Cleaning and
maintenance', section 'Emptying and cleaning the dust
container')
If brushing does not help to clean the filter, replace
the filter with a new one (see chapter 'Replacement',
section 'Replacing the filter' and chapter 'Ordering
accessories').
Clean the suction opening (see chapter 'Cleaning
and maintenance', section 'Cleaning the suction
opening, the wheels and the drop-off sensors').
Clean the front wheel (see chapter 'Cleaning and
maintenance', section 'Cleaning the suction opening,
the wheels and the drop-off sensors').