Assembly - Harken 35.2 ST Installation And Maintenance Manual

Assembly

Make sure that the holes and drainage channels in the base of the winch are not obstructed
Assemble the winch in the reverse order of the sequence in the section on disassembly.
To tighten bolts, use the torque indicated in the disassembly procedure.
When positioning the stripper arm,
align the peeler with it.
In case of doubt concerning the assembly procedure contact Harken
35.2 ST
Radial Winch
If the jaws have been disassembled,
insert peeler between the two jaws,
taking care that the letters TOP on the
peeler are facing upwards.
To assemble the pawls:
correctly position the spring in its housing as
shown at left. Hold the spring closed and slide
OIL
the pawl into its housing. Once in position,
check that the pawls can be easily opened and
closed with a finger.
14
®
Tech Service: techservice@harken.it
Installation and Maintenance Manual