Advertisement
7.
Remove the vehicle harness clip from the vehicle
frame, and move the clip out of the way.
PLAYER BASE-
BRACKET
6 mm
FLANGE
NUT
VEHICLE HARNESS CLIP
(Insert into the hole of
the player base bracket.)
8.
Insert the studs from the player base-bracket into
the holes in the vehicle frame from the back.
Install the two 6 mm flange nuts while holding the
bracket firmly against the vehicle frame. Insert the
vehicle harness clip (removed in step 7) into the
hole in the player base-bracket.
9.
Insert the studs of the left and right player
subbrackets into the holes in the vehicle frame,
and install one 6 mm flange nut on the end of
each stud while pushing each subbracket upward.
6 mm FLANGE NUT
VEHICLE
FRAME
LEFT PLAYER
SUBBRACKET
RIGHT PLAYER
SUBBRACKET
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
VEHICLE
VEHICLE
FRAME
HARNESS
CLIP
(Remove.)
VEHICLE
FRAME
6 mm
FLANGE
2306011T
NUT
VEHICLE
FRAME
2306021T
AII 24378 (0303)
10. Get the pocket from the audio attachment kit.
Using a utility knife, cut the two lugs off of the
pocket.
LUG
(Cut.)
POCKET
LUG
11. Install one latch onto the left and right player
brackets. Slide the clip nut onto the display
module pocket flange.
1 mm
LATCH
SELF-TAPPING
SCREW (2)
(Supplied
with audio
attachment kit)
LEFT
POCKET
PLAYER
BRACKET
SCREW
POSITION
12 Set the display module pocket on the pocket with
the cut out facing up. Position the left and right
player brackets on the display module pocket and
pocket, and install five self-tapping screws.
2529041T
LATCH
DISPLAY
MODULE
POCKET
FLANGE
CLIP NUT
DISPLAY
MODULE
POCKET
SELF-TAPPING
SCREWS (3)
(Supplied with
XM radio
attachment kit)
RIGHT
PLAYER
BRACKET
2N28071M
BRACKET
HOLE
7 of 24
Advertisement
